Viewing and checking GDS in KLayout¶
KLayout is the free, open-source layout viewer most groups use to inspect a mask before sending it out. Two small files help it read a GDS exported by Quantum Metal:
quantum-metal.lyp, a layer-properties file that names and colors each layer and datatype.quantum-metal-basic.drc, a starter design-rule deck that flags thin features, narrow gaps and tiny islands.
Both were tried on a chip exported by QGDSRenderer; see the notes at the end for
what they do not cover.
Export the chip¶
Export a design with design.renderers.gds.export_to_gds("my_chip.gds"). The
tutorials 1.4 Saving your chip design
and 3.2 Export your design to GDS
walk through the options, including cheesing and the fabrication export.
Color the layers¶
Open the GDS in KLayout (klayout my_chip.gds), then choose
File → Load Layer Properties and select quantum-metal.lyp. The file lists
design layers 1 to 4. For a design with more layers, copy one block in the file
and change its layer number.
Quantum Metal writes each design layer as a GDS layer, and uses the datatype to say what a shape is:
Datatype |
Contents |
|---|---|
10 |
Polygons: qubit pads, launchpads, and the ground-plane outline. |
11 |
Paths: CPW traces. |
0 |
The ground plane with its cut-outs, in the negative-mask export. |
100 |
Cheese holes ( |
99 |
The no-cheese keep-out region, for viewing only
( |
101, 102 |
Working geometry for the cheese step. The layer file hides them. |
The cheese and no-cheese datatypes are options, so if you changed them, change the numbers in the layer file to match.
Run the design-rule deck¶
From the command line:
klayout -b -r quantum-metal-basic.drc -rd input=my_chip.gds -rd report=drc_report.lyrdb
Then open the GDS in KLayout and load the report with Tools → Marker Browser. The deck reads the metal on one design layer (polygons and paths, minus the cheese holes) and reports:
min_width: metal narrower than the minimum width;min_space: a gap between metal shapes narrower than the minimum spacing;min_area: a metal island smaller than the minimum area.
Set the thresholds on the command line, for example
-rd min_width=2 -rd min_space=3 -rd min_area=10 (micrometers and square
micrometers), and the design layer with -rd layer=2. The defaults are
placeholders. Take the numbers from your fab’s design rules before relying on the
result.
Notes¶
The deck is a starting point. It does not know about your process: no layer stack, no junction rules, no antenna or airbridge rules.
Quantum Metal has its own checks that run before export:
from qiskit_metal.validation import validate; print(validate(design).report())catches problems such as unterminated CPW ends and starved fillets at the design stage. GDS-level checks are the job of KLayout and your fab’s rule deck.Junctions appear in the GDS only if you set
path_filenameto a GDS file that holds the junction cells (see tutorial 1.4).